This page contains the procedure for checking if production runs are of good quality and can be used for physics analysis.
Run Periods
Procedure
For each production run, do the following:
- Go to the | Offline Run Browser page.
- Follow the steps outlined in the checklist below.
- Certify that each section is okay
- (DB + script to be developed)
- Set run status = 1 in RCDB
Run Statuses
- -1 - unchecked
- 0 - rejected (not physics-quality)
- 1 - approved
- 2 - approved long/"mode 8" data
- 3 - calibration / systematic studies
Checklist
Reference run for 2017-01: 30780
Reference run for 2018-01: 40933/4
- BCAL
- Check Occupancy - Reference: [ link ]
- Check Hit Efficiency - Reference: [ link ]
- Check BCAL Recon. 1 - Reference: [ link ]
- Check BCAL Recon. 2 - Reference: [ link ]
- Check BCAL Matching - Reference: [ link ]
- CDC
- Check Occupancy - Reference: [ link ]
- Check Time-to-distance - Reference: [ link ]
- Check CDC ROC amp - Reference: [ link ]
- Check CDC ROC netamp - Reference: [ link ]
- Check CDC ROC hits - Reference: [ link ]
- Check CDC rawtime vs strawnum. - Reference: [ link ]
- FCAL
- Check Occupancy - Reference: [ link ]
- Check FCAL Hits 1 - Reference: [ link ]
- Check FCAL Hits 2 - Reference: [ link ]
- Check FCAL Clusters 1 - Reference: [ link ]
- Check FCAL Recon. 1 - Reference: [ link ]
- Check FCAL Recon. 2 - Reference: [ link ]
- Check FCAL Matching - Reference: [ link ]
- FDC
- Check Package 1 Occupancy - Reference: [ link ]
- Check Package 2 Occupancy - Reference: [ link ]
- Check Package 3 Occupancy - Reference: [ link ]
- Check Package 4 Occupancy - Reference: [ link ]
- PS
- Check Occupancy - Reference: [ link ]
- Check Timing Alignment - Reference: [ link ]
- SC
- Check Occupancy - Reference: [ link ]
- Check SC Recon. 1 - Reference: [ link ]
- Check SC Recon. 2 - Reference: [ link ]
- Check SC Matching - Reference: [ link ]
- TAGH
- Check Tagger Occupancy - Reference: [ link ]
- Check TAGH Hits 2 - Reference: [ link ]
- TAGM
- Check Timing ADC-RF - Reference: [ link ]
- Check Timing T-ADC - Reference: [ link ]
- TOF
- Check Occupancy - Reference: [ link ]
- Check TOF Matching 1 - Reference: [ link ]
- Check TOF Matching 2 - Reference: [ link ]
- RF
- Check timing offsets - Reference: [ link ]
- Should be centered around zero
- Timing
- Check Calorimeter Timing - Reference: [ link ]
- Check Drift Chamber Timing - Reference: [ link ]
- Check PID System Timing - Reference: [ link ]
- Check Tagger Timing - Reference: [ link ]
- Check Track Matched Timing - Reference: [ link ]
- Check Tagger/RF Timing - Reference: [ link ]
- Check Tagger/SC Timing - Reference: [ link ]
- Analysis
- Tracking 1 - [ link ]
- Tracking 3 - [ link ]
- Check BCAL pi0 - Reference: [ link ]
- Check BCAL/FCAL pi0 - Reference: [ link ]
- Check p+2pi - Reference: [ link ]
- Check p+3pi - Reference: [ link ]
- Check p+pi0g - Reference: [ link ]