Difference between revisions of "Testing of PMT dividers"

Revision as of 09:27, 26 May 2023

New version of the active base

• 

  Fig. 1 Connectors on the new base

• 

  Fig. 2 Connectors on the new base

• 

  Fig. 3 Extension of the PCB to accommodate the new connector

Bench tests

• 

  Fig. 1 Setup for testing PMT dividers

• 

  Fig. 2 Bypassed amplifier, small amplitude

• 

  Fig. 3 Bypassed amplifier, large amplitude

• 

  Fig. 3 Amplifier gain 3, small amplitude

Study noise inside FCAL

Installing 5x5 prototype on CCAL

• 

  Fig. 1 - Front view of the CCAL

• 

  Fig. 2 - Rear view of the CCAL

• 

  Fig. 3 - List of modules installe

Cables, and patch panels

• 

  Fig. 1 - Cables connected to the FCAL2 dividers (signal, HV, and LV)

• 

  Fig. 2 - Cables connected to the FCAL2 dividers (signal, HV, and LV)

• 

  Fig. 3 - Closer look of dividers

• 

  Fig. 4 - Patch panels: LV distribution for the 5x5 prototype (right)

• 

  Fig. 5 - Patch panel from the outside of the CCAL (the MPOD connector is on the left)

Tuning dividers after the CCAL beam test

• Before saturation.jpg

  Fig. 1 Original base before saturation