Difference between revisions of "Testing of PMT dividers"
From GlueXWiki
| Line 32: | Line 32: | ||
Image:ccal_prot_cables2.jpg | Fig. 3 - Closer look of dividers | Image:ccal_prot_cables2.jpg | Fig. 3 - Closer look of dividers | ||
Image:ccal_prot_cables4.jpg | Fig. 4 - Patch panels: LV distribution for the 5x5 prototype (right) | Image:ccal_prot_cables4.jpg | Fig. 4 - Patch panels: LV distribution for the 5x5 prototype (right) | ||
| − | Image:ccal_prot_cables5.jpg | Fig. 5 - Patch panel from the outside of the CCAL | + | Image:ccal_prot_cables5.jpg | Fig. 5 - Patch panel from the outside of the CCAL (the MPOD connector is on the left) |
</gallery> | </gallery> | ||
Revision as of 18:49, 13 February 2023
Bench tests
Fig. 1 Setup for testing PMT dividers
Fig. 2 Bypassed amplifier, small amplitude
Fig. 3 Bypassed amplifier, large amplitude
Fig. 3 Amplifier gain 3, small amplitude
Installing 5x5 prototype on CCAL
Fig. 1 - Front view of the CCAL
Fig. 2 - Rear view of the CCAL
Fig. 3 - List of modules installe
Cables, and patch panels
Fig. 1 - Cables connected to the FCAL2 dividers (signal, HV, and LV)
Fig. 2 - Cables connected to the FCAL2 dividers (signal, HV, and LV)
Fig. 3 - Closer look of dividers
Fig. 4 - Patch panels: LV distribution for the 5x5 prototype (right)
Fig. 5 - Patch panel from the outside of the CCAL (the MPOD connector is on the left)
