Difference between revisions of "Microscope Readout Cable Lengths and Routes"
m |
|||
| Line 1: | Line 1: | ||
Calculations were made using drawings of the tagger hall to determine how far the TAGM and its cables will reach along the focal plane. | Calculations were made using drawings of the tagger hall to determine how far the TAGM and its cables will reach along the focal plane. | ||
| − | It was determined that, depending on which splitter in the TAGM rack is used, the cables will reach between 139 - 165 +/- | + | It was determined that, depending on which splitter in the TAGM rack is used, the cables will reach between 139 - 165 +/- 8 inches in either direction along the vacuum chamber in the focal plane. This only applies if the pivot is made from position D as seen in [[Media:AMCCable_Calculations.pdf| Cable Calculations]]. This has lead us to conclude that it would be more advantageous to go into the TAGM lower enclosure cable tray via the upstream side. |
| − | The necessary reach at the focal plane in either direction for our purposes (e.g. | + | The necessary reach at the focal plane in either direction for our purposes (e.g. rare eta decay experiment) was determined to be 109.5 inches. If the pivot is made at position E, as seen in the [[Media:AMCCable_Calculations.pdf| Cable Calculations]], the length will not be sufficient, since the cables would only reach as far as 98 inches in either direction along the focal plane. |
Revision as of 13:18, 9 September 2013
Calculations were made using drawings of the tagger hall to determine how far the TAGM and its cables will reach along the focal plane.
It was determined that, depending on which splitter in the TAGM rack is used, the cables will reach between 139 - 165 +/- 8 inches in either direction along the vacuum chamber in the focal plane. This only applies if the pivot is made from position D as seen in Cable Calculations. This has lead us to conclude that it would be more advantageous to go into the TAGM lower enclosure cable tray via the upstream side.
The necessary reach at the focal plane in either direction for our purposes (e.g. rare eta decay experiment) was determined to be 109.5 inches. If the pivot is made at position E, as seen in the Cable Calculations, the length will not be sufficient, since the cables would only reach as far as 98 inches in either direction along the focal plane.
