Difference between revisions of "GlueX phase 2, 2023-01 data set"
(→What is currently in the default variation) |
(→Checking the FCAL gains) |
||
| Line 68: | Line 68: | ||
== [[ Checking the FCAL gains ]] == | == [[ Checking the FCAL gains ]] == | ||
| + | |||
| + | Look at the reports and individual diphoton invariant mass. | ||
== Energy dependence correction monitoring plots == | == Energy dependence correction monitoring plots == | ||
Revision as of 10:01, 30 December 2023
Contents
List of changes
These lists are giving the run ranges where the FCAL hardware was not changed.
Monitoring results
What is currently in the default variation
The default variation contains the latest and most up-to-date tables.
Periods
| Min Run | Max Run | Batch # | Gains |
|---|---|---|---|
| 120297 | 120444 | 1 | [1] |
| 120445 | 120679 | 2 | [2] |
| 120680 | 120790 | 3 | [3] |
| 120791 | 120894 | 4 | [4] |
| 120910 | 121092 | 5 | [5] |
| 121093 | 121207 | 6 | [6] |
Timing
Done for each batches above.
Pedestals
The pedestal calibration is performed for each block & run. When there is no response to LED lights, the block is marked as a potential bad block and is set arbitrarily to a pedestal value corresponding to the average pedestal value for the runs in which this block sees the LED lights.
Map of missing pedestals or blocks integrated over all runs
Change of the pedestal value from the nominal pedestal vs block number overall runs
Gain matching calibration plots
Checking the FCAL gains
Look at the reports and individual diphoton invariant mass.
Energy dependence correction monitoring plots
Bad block map
This map is done for each run number by combining the info collected by analyzing the LED and pi0 skims.
