Difference between revisions of "GlueX phase 2, 2023-01 data set"
From GlueXWiki
(→Pedestals) |
(→Pedestals) |
||
Line 59: | Line 59: | ||
[https://halldweb.jlab.org/wiki/images/4/47/BadPedMap.png Map of missing pedestals or blocks integrated over all runs] | [https://halldweb.jlab.org/wiki/images/4/47/BadPedMap.png Map of missing pedestals or blocks integrated over all runs] | ||
− | [https://halldweb.jlab.org/wiki/images/0/0b/FCALPedDiff.png] | + | [https://halldweb.jlab.org/wiki/images/0/0b/FCALPedDiff.png Change of the pedestal value from the nominal pedestal vs block number over all runs] |
== Gain matching calibration plots == | == Gain matching calibration plots == |
Revision as of 10:09, 29 December 2023
Contents
List of changes
These lists are giving the run ranges where the FCAL hardware was not changed.
Monitoring results
What is currently in the default variation
Periods
Min Run | Max Run | Batch # | Gains |
---|---|---|---|
120297 | 120444 | 1 | [1] |
120445 | 120679 | 2 | [2] |
120680 | 120790 | 3 | [3] |
120791 | 120894 | 4 | [4] |
120910 | 121092 | 5 | [5] |
121093 | 121207 | 6 | [6] |
Timing
Done for each batches above.
Pedestals
The pedestal calibration is performed for each run.
Map of missing pedestals or blocks integrated over all runs
Change of the pedestal value from the nominal pedestal vs block number over all runs
Gain matching calibration plots
Checking the FCAL gains
Energy dependence correction monitoring plots
Bad block map
This map is done for each run number by combining the info collected by analyzing the LED and pi0 skims.