Difference between revisions of "TODO reprocessing 2017-01 data"
From GlueXWiki
(→FCAL plots) |
(→Need to do) |
||
Line 6: | Line 6: | ||
* Recalibrate inner FCAL blocks | * Recalibrate inner FCAL blocks | ||
** Decide if we should use the Primex calibration procedure | ** Decide if we should use the Primex calibration procedure | ||
− | * Check tagger calibrations | + | * Check tagger calibrations (timing) |
+ | * Tagger energy calibration | ||
* Benchmark reconstruction software against 2019-11 software version | * Benchmark reconstruction software against 2019-11 software version | ||
Revision as of 17:47, 27 May 2022
Contents
Things to do before reprocessing the 2017 data with the latest software
Need to do
- Recalibrate inner FCAL blocks
- Decide if we should use the Primex calibration procedure
- Check tagger calibrations (timing)
- Tagger energy calibration
- Benchmark reconstruction software against 2019-11 software version
Would like to do
- Figure out drift chamber alignment
- study matching to single FCAL blocks
- detailed tagger energy calibration
- better calibration of high energy FCAL showers
FCAL plots
pi0 mass for inner blocks in run period 2017-01 (run 30730) - 25 April 2022 (pdf)
pi0 mass for inner blocks in run period 2018-08 (run 51227) - 25 April 2022 (pdf)
pi0 mass for inner blocks In run period 2017-01 (note that these plots were made using the pi0 skims, whereas the above plots were made with the full raw data, so ignore this plot!! the pi0 skims explicitly rejected in the inner FCAL layers)- 20 April 2022