Difference between revisions of "February 16, 2021"
From GlueXWiki
(Created page with "* [https://halldweb.jlab.org/detectors/fcal2/dividers/design_meeting_2_16_2021/fcal_amp_lin.pdf Amplifier linearity tests] '''CCAL discussion''' * Order (refurbish) divid...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | '''Connection instructions''': | ||
+ | |||
+ | * If connecting via '''Web Browser''': click this link (no passcode is needed): | ||
+ | ** https://bluejeans.com/7572695553 | ||
+ | * If connecting via '''Phone''': Dial one of the following numbers and then enter the meeting ID above and hit "#" or "##" | ||
+ | ** Dial: 1 888 240 2560 (US or Canada only) | ||
+ | |||
+ | |||
+ | |||
* [https://halldweb.jlab.org/detectors/fcal2/dividers/design_meeting_2_16_2021/fcal_amp_lin.pdf Amplifier linearity tests] | * [https://halldweb.jlab.org/detectors/fcal2/dividers/design_meeting_2_16_2021/fcal_amp_lin.pdf Amplifier linearity tests] | ||
Latest revision as of 12:43, 15 February 2021
Connection instructions:
- If connecting via Web Browser: click this link (no passcode is needed):
- If connecting via Phone: Dial one of the following numbers and then enter the meeting ID above and hit "#" or "##"
- Dial: 1 888 240 2560 (US or Canada only)
CCAL discussion
- Order (refurbish) dividers, use bypassed amplifier (and gain of 3)
FCAL insert
- expected anode current < 20 uA in the inner most FCAL insert layer; current drops rapidly with the radial distance
- (used CCAL in GlueX runs at high luminosity)
- likely do not need an amplifier in most FCAL insert layers
- Do we need to modify the amplifier ?
- - modify the active base
- - redesign an amplifier, use additional power line to supply the on-board amplifier
- - use external amplifiers (position in the FCAL dark room)
- - do not modify the active base, apply non-linearity corrections