Hovanes' proposal for crate naming
From GlueXWiki
This scheme follows the original Hall B crate naming scheme.
- Each major detector component will have a number of crates named based on its GlueX name, followed by one or two digits specifying the number of the crate.
- If more than one detector component is a part of one crate only one name is assigned, probably larger one.
- Numbering assignment with respect to the geographical location (the map) will need to be created out before requesting IP names.
- Ordering by the type of the boards, then followed by geographical location ordering?
- Geographical location ordering only?
- In the table below I separated the crates with the JLab discriminators from the other crates, but we can associate them with the detector subsystem as well.
| Detector | Crate Names | Possible modules |
|---|---|---|
| TAGM/TAGH | tag1 - tag3 | fADC250/F1TDC |
| PS/PSC | ps1 - ps2 | fADC250/F1TDC |
| ST | st1 - st2 | fADC250/F1TDC |
| TRIG | trig1 - trig2 | GTP/TS/TD |
| BCAL | bcal1 - bcal12 | fADC250/F1TDC |
| CDC | cdc1 - cdc4 | fADC125 |
| FDC | fdc1 - fdc14 | fADC125/F1TDC |
| TOF | tof1 - tof2 | fADC250/CAEN TDC |
| FCAL | fcal1 -fcal12 | fADC250 |
| DISC | dscr1 -dscr8 | JLab Discriminators |
