August 26, 2010 Des/Fab Meeting

Meeting Time and Place

Thursday Aug 26, 2010 at 8:15am At Jefferson Lab, the meeting will be held in room ARC 428

Determine new positions of cryo transfer line supports and feedback to civil (Jim/Tim)* Under work - needs to be settled within the next few weeks
Correct platform height and location for new expansion can (make sure there is room to stab u-tubes)(Jim/Rich)* Some work done, will review next week
Need to develop a leak check and assy plan for cryo lines (Jim/Tom) in work
Consult with Scot and Mark on cryo instrumentation (Jim) in work - met with J. Creel from cryo - P&I diagrams given for review
Look at getting traps/strainers for power supply LCW (Tom)
Identify PLC programmer to take over for Mark Wissman (Tim)
Need to put PR out for FDC techs (Tim)

- In attendance W. Crahen, G. Biallas, J. Fochtman, T. Carstens, C. Hutton, V. Razmyslovich, J. Lagner, F. Martin, R. Getz, J. Foyles, M. Stevens, R. Bunton, G. Humble, C. Heck, D. Butler, K. Sullivan, Josh Ballard, W. Sachleben, Tim Whitlatch

Discussed what to do with DOPS money ($12K). Tom suggested renting a man lift for testlab.
Discussed status of coil test. Tom Felt we were running into October before we can get cold. George stated that there was light at the end of the tunnel for completing the design work for the test.(only vaccum circuit, cryo connections and overall assy left)
Discussed upcoming (Dec) availability of the hall and what needs to happen when it is ready.
- Need to develop plans for LCW and electrical
- Big Bertha will be needed
- Will we need cooling for crates?
- Need to fabricate stands, etc.. for installation in collimator cave (including survey and alignment)