Difference between revisions of "Time-of-Flight/Start-Counter Meeting, May 29, 2009"
(→Agenda) |
(Mark's notes, not minutes) |
||
| Line 15: | Line 15: | ||
# Start Counter Geometry: Sascha/Chuck | # Start Counter Geometry: Sascha/Chuck | ||
# Schedules | # Schedules | ||
| + | |||
| + | =Minutes= | ||
| + | |||
| + | mark elliott, sascha sasha simon paul | ||
| + | |||
| + | new trigger counters | ||
| + | sasha with an s | ||
| + | with machine shop, designing prototype light guide | ||
| + | drawing, back of envelope ish | ||
| + | will make one, bend and test | ||
| + | elliott will get flash adc | ||
| + | elliott on mailing list? | ||
| + | remove center p0 connection tool for 64x crates | ||
| + | get software from dave abbott | ||
| + | cfd loaner was purchased caen | ||
| + | |||
| + | sasha | ||
| + | plans | ||
| + | measurements for time resolution, 600 ps, from leading edge discriminator, will try cfd | ||
| + | |||
| + | measure efficiency | ||
| + | trigger, end left, end right | ||
| + | use scalers | ||
| + | |||
| + | paul looking at undergraduate to help with measurments and software improvements | ||
| + | |||
| + | sascha questions | ||
| + | different trigger types for tof detectors | ||
| + | trigger electronics board | ||
| + | monitoring will piggyback off calorimeter calibration system | ||
| + | cosmic | ||
| + | |||
| + | |||
| + | chuck thinks there is room to start bending early | ||
| + | |||
| + | revisit schedule issue | ||
Revision as of 15:17, 29 May 2009
Location, Time
Friday, May 29, 2009
3:00 pm EDT
JLab: CEBAF Center, Room F326/327
ESNet: 8542553
EVO: direct meeting link
Conference Group: 800-377-8846, participant code: 39527048
Agenda
- Time-of-Flight Status: Paul/Sasha
- Start Counter Status: Werner
- Start Counter Geometry: Sascha/Chuck
- Schedules
Minutes
mark elliott, sascha sasha simon paul
new trigger counters sasha with an s with machine shop, designing prototype light guide
drawing, back of envelope ish
will make one, bend and test elliott will get flash adc elliott on mailing list? remove center p0 connection tool for 64x crates get software from dave abbott cfd loaner was purchased caen
sasha plans measurements for time resolution, 600 ps, from leading edge discriminator, will try cfd
measure efficiency trigger, end left, end right use scalers
paul looking at undergraduate to help with measurments and software improvements
sascha questions different trigger types for tof detectors trigger electronics board monitoring will piggyback off calorimeter calibration system cosmic
chuck thinks there is room to start bending early
revisit schedule issue
