Difference between revisions of "Shaper gain"
From GlueXWiki
m |
m (→Output signals below 500 mV (Fe-55) - 1750 V) |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 36: | Line 36: | ||
| − | === Output signals below | + | === Output signals below 550 mV (Fe-55) - 1750 V=== |
{| border="1" cellpadding="2" | {| border="1" cellpadding="2" | ||
|- | |- | ||
| − | |width="415pt"|[[Image:shapergaintrace1b.jpg|thumb|none|400px|Scope trace: ( | + | |width="415pt"|[[Image:shapergaintrace1b.jpg|thumb|none|400px|Scope trace: (green) before shaper, after 18 meter of cable - (blue) after shaper ]] |
| − | |width="415pt"|[[Image:shapergaintrace2b.jpg|thumb|none|400px|Scope trace: ( | + | |width="415pt"|[[Image:shapergaintrace2b.jpg|thumb|none|400px|Scope trace: (green) before shaper, after 18 meter of cable - (blue) after shaper ]] |
| − | |width="415pt"|[[Image:shapergaintrace3b.jpg|thumb|none|400px|Scope trace: ( | + | |width="415pt"|[[Image:shapergaintrace3b.jpg|thumb|none|400px|Scope trace: (green) before shaper, after 18 meter of cable - (blue) after shaper ]] |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
|- | |- | ||
|} | |} | ||
Latest revision as of 18:37, 7 August 2008
50 Ohm input resistance of the input signals
1 MOhm input resistance of the two input signals
