Difference between revisions of "Semi-Automatic Field Mapping Logger"
From GlueXWiki
(→Files) |
|||
Line 21: | Line 21: | ||
Field_Data_20130501_1139_P90_R12.dat | Field_Data_20130501_1139_P90_R12.dat | ||
+ | |||
+ | The columns of a data file are: radius(inch), phi(deg), Z(cm), Incline(deg), B_x(Gauss), B_y(Gauss), B_z(Gauss) and B_axial(Gauss). | ||
+ | And the X,Y,Z direction are defined as | ||
+ | * X: points to the beam left | ||
+ | * Y: points vertically up | ||
+ | * Z: points to beam dump |
Revision as of 19:26, 19 June 2013
Field Mapping System Diagram
Running the Field Logger Software
1. Use remote desktop to log onto halld2 using account 'JLAB\halldusers', ask Elliott for password
rdesktop halld2 -g 1800x1000
2. Double click the shortcut Field_Logger on the desktop to run the LabVIEW application
Files
The files are stored on the halld-online group disk here:
/group/halld-online/Solenoid_Mapping
Which should also be accessible from the "M:" drive
The file names are formatted to contain the date, start time, phi value, and radius. For example, the following file was:
- created on May 1st, 2013 at 11:39am
- the strut was positioned such that the tube positions were along φ=90o
- tube was at R=0 (i.e. along the center of the magnet).
Field_Data_20130501_1139_P90_R12.dat
The columns of a data file are: radius(inch), phi(deg), Z(cm), Incline(deg), B_x(Gauss), B_y(Gauss), B_z(Gauss) and B_axial(Gauss). And the X,Y,Z direction are defined as
- X: points to the beam left
- Y: points vertically up
- Z: points to beam dump