Difference between revisions of "Run Planning Meeting Notes, July 27-August 5, 2020"
From GlueXWiki
m (→Aug. 3rd) |
(→Aug. 3rd) |
||
| Line 37: | Line 37: | ||
[https://logbooks.jlab.org/entry/3819971 Run plan for today] | [https://logbooks.jlab.org/entry/3819971 Run plan for today] | ||
| + | Tasks completed: | ||
*Took 1h "production" (with TagM down) amorphous run. | *Took 1h "production" (with TagM down) amorphous run. | ||
*[https://logbooks.jlab.org/entry/3820227 Hovanes finalized the optimization of the transmission.] Optimal transmission is obtained for: | *[https://logbooks.jlab.org/entry/3820227 Hovanes finalized the optimization of the transmission.] Optimal transmission is obtained for: | ||
| Line 42: | Line 43: | ||
**AC: X = 0.8 Y = -0.4 | **AC: X = 0.8 Y = -0.4 | ||
*[https://logbooks.jlab.org/entry/3820171 TagM fixed after 1:30pm-4:4-pm access]. Sergey and Lubomir worked opportunistically in the Hall on TRD during Tagger access. | *[https://logbooks.jlab.org/entry/3820171 TagM fixed after 1:30pm-4:4-pm access]. Sergey and Lubomir worked opportunistically in the Hall on TRD during Tagger access. | ||
| + | *TagM HV scan. | ||
| + | |||
| + | Tasks to be done: | ||
| + | *Hovanes to check JD70-105 diamond alignement | ||
*Sacha finalized the trigger check out | *Sacha finalized the trigger check out | ||
| + | *One production cycle at 150nA | ||
| + | *Start regular production. | ||
Issues: | Issues: | ||
Revision as of 22:17, 3 August 2020
<- Back to Run coordination meeting page
July 27th-Aug. 2nd
- Beni ramped up the solenoid on Aug. 1st. However, due to a problem with the PXI readout, it was ramped down. The solenoid was ramp-up again (Aug. 2nd) to its nominal 1350A, this time without problem.
- Target was cooled (C. Keith) and latter filled without problem (Aug. 1st)
- Shift Started on Aug. 1st, 8am.
August 1st-2nd : investigating and attempting to fix a problem with the front-end of the TagM. Did two long accesses to tagger, but the problem remains. Due to this, the runplan for August 3-4 has been reorganized
- CW beam arrived around 3am on Aug. 2nd, followed by beam quality checks.
- Radiation levels are good.
- Beam convergence is good
- Beam position optimized (?), however transmission doesn't appear to be optimal
- trigger checked out
- Radiation level study done.
- 15 min calibration runs (in long and production mode) done
- CDC HV scan ongoing.
Issues:
- TagM
- We often get less beam current than requested
- DAQ start run issue: reminder of DIRC mis-communication solution
- Difficulty in setting CDC HV for CDV HV scan, see also Keigo's entry. It was fixed by rebooting the IOC.
Upcoming days:
- Hurricane/tropical storm Isaias
- TagM communication issue
- Week 1 time chart
- Richard plan for Act. Col. test
- Thursday: 1->5 pass change for Hall B. Hall A on-line.
- Tuesday 11th: Maintenance day?
Aug. 3rd
Tasks completed:
- Took 1h "production" (with TagM down) amorphous run.
- Hovanes finalized the optimization of the transmission. Optimal transmission is obtained for:
- Profiler: X = - 1.8 Y = - 2.1
- AC: X = 0.8 Y = -0.4
- TagM fixed after 1:30pm-4:4-pm access. Sergey and Lubomir worked opportunistically in the Hall on TRD during Tagger access.
- TagM HV scan.
Tasks to be done:
- Hovanes to check JD70-105 diamond alignement
- Sacha finalized the trigger check out
- One production cycle at 150nA
- Start regular production.
Issues:
- Instable beam current (since the start of the run)
- Monitoring discrepancy: Hovanes observation, Naomi and Justin replies
- missing evio files
Reports:
Upcoming days:
- Hurricane/tropical storm Isaias
- TagM communication issue
- Week 1 time chart
- Richard plan for Act. Col. test
- Thursday: 1->5 pass change for Hall B. Hall A on-line.
- Tuesday 11th: Maintenance day?
