Difference between revisions of "Preparation for 2021 Run"
From GlueXWiki
(Created page with "[https://logbooks.jlab.org/entry/3810770 Status of FCAL dividers in 3 inner rings]") |
|||
| Line 1: | Line 1: | ||
| + | Below are some action items which we would like to fix before the PrimEx Phase II run in | ||
| + | Spring/Summer 2021. | ||
| + | |||
| + | |||
| + | # Aligning FCAL in the Hall; moving by about 5 mm on X to make sure that the | ||
| + | beam goes through the middle of the hole. The exact position should be confirmed by the | ||
| + | the alignment group -- Tim Whitlatch | ||
| + | |||
[https://logbooks.jlab.org/entry/3810770 Status of FCAL dividers in 3 inner rings] | [https://logbooks.jlab.org/entry/3810770 Status of FCAL dividers in 3 inner rings] | ||
Revision as of 15:49, 10 September 2020
Below are some action items which we would like to fix before the PrimEx Phase II run in Spring/Summer 2021.
- Aligning FCAL in the Hall; moving by about 5 mm on X to make sure that the
beam goes through the middle of the hole. The exact position should be confirmed by the the alignment group -- Tim Whitlatch
