Difference between revisions of "June 30, 2009 CDC Meeting"
From GlueXWiki
(→Notes) |
(→Notes) |
||
Line 26: | Line 26: | ||
** <b>OPEN</b> How thick is ring on which inner tube is glued? | ** <b>OPEN</b> How thick is ring on which inner tube is glued? | ||
** Threaded inserts? These are for screwing in the gas plenum. Used in conjunction with the above mentioned groove to position plenum. | ** Threaded inserts? These are for screwing in the gas plenum. Used in conjunction with the above mentioned groove to position plenum. | ||
+ | ** | ||
+ | * Holes Sizes | ||
+ | |||
+ | * Crimp pin to plastic insert - CMU will think about the fit. | ||
+ | ** Plastic inserts are all the same, make go 0.1" past the feed-thru.(Looks like 1.2). | ||
+ | |||
+ | * Donuts and feed through both have glue port and vent. | ||
+ | * Feed through groove moved from 0.19 to 0.25" from tip on both Noryl and Al. | ||
+ | * Depth of drilled holes changes (Noryl is 0.55", AL is 0.7"). |
Revision as of 12:10, 30 June 2009
Meeting Time and Place
Tuesday June 30 2009 at 11:00am At Jefferson Lab, the meeting will be held in room ARC 428
Connections
To connect from the outside, please use ESNET
1.) ESNET: 8542553
2.) Phone:
+1-800-377-8846 : US
+1-888-276-7715 : Canada
+1-302-709-8424 : International
then enter participant code: 39527048# (remember the "#")
Agenda
- CDC Endplate Drawings Drawings
- CDC Donut/Feedthru Drawings Donuts
Notes
- CDC Front Disc
- Section B-B, what is the small step? Small step to engage the inner hub.
- What will hold the inner tube to the end plates? Without the gas plenum, there is 3/8" on radius and after the polycarbonate, at least that much.
- OPEN How thick is ring on which inner tube is glued?
- Threaded inserts? These are for screwing in the gas plenum. Used in conjunction with the above mentioned groove to position plenum.
- Holes Sizes
- Crimp pin to plastic insert - CMU will think about the fit.
- Plastic inserts are all the same, make go 0.1" past the feed-thru.(Looks like 1.2).
- Donuts and feed through both have glue port and vent.
- Feed through groove moved from 0.19 to 0.25" from tip on both Noryl and Al.
- Depth of drilled holes changes (Noryl is 0.55", AL is 0.7").