Difference between revisions of "Charge division"
From GlueXWiki
m |
m |
||
| Line 1: | Line 1: | ||
| − | + | {| border="1" cellpadding="2" | |
|- | |- | ||
|width="415pt"|[[Image:chargedivision.jpg|thumb|none|400px| The resistor (the one shown will most likely not be used) is about 9~cm away from the crimp pin(s).]] | |width="415pt"|[[Image:chargedivision.jpg|thumb|none|400px| The resistor (the one shown will most likely not be used) is about 9~cm away from the crimp pin(s).]] | ||
|width="415pt"|[[Image:chargedivision2.jpg|thumb|none|400px| Better be safe. ]] | |width="415pt"|[[Image:chargedivision2.jpg|thumb|none|400px| Better be safe. ]] | ||
| + | |- | ||
| + | |} | ||
| + | |||
| + | == Some signals == | ||
| + | {| border="1" cellpadding="2" | ||
| + | |- | ||
| + | |width="415pt"|[[Image:signals-31cm.jpg|thumb|none|400px| Source at 31 cm .]] | ||
| + | |width="415pt"|[[Image:signals-128cm.jpg|thumb|none|400px| Source at 128 cm.]] | ||
| + | |width="415pt"|[[Image:signals-192cm.jpg|thumb|none|400px| Source at 192 cm.]] | ||
| + | |- | ||
| + | |} | ||
| + | |||
| + | |||
| + | == Measurements and resolution == | ||
| + | {| border="1" cellpadding="2" | ||
| + | |- | ||
| + | |width="415pt"|[[Image:amp-ratio.jpg|thumb|none|400px| Amplitude ratio.]] | ||
| + | |width="415pt"|[[Image:res.jpg|thumb|none|400px| Resolution.]] | ||
| + | |width="415pt"|[[Image:res-zoom.jpg|thumb|none|400px| Resolution zoom.]] | ||
|- | |- | ||
|} | |} | ||
Latest revision as of 14:07, 21 January 2009
Some signals
