BCAL Calibration
From GlueXWiki
Steps in Calibration
macros are located at /group/halld/Users/dalton/BCAL/monitoring/macros/
- Remove 4ns ADC hardware offset (pass 1)
- Run reconstruction with BCAL_TDC_Timing plugin to produce the BCAL_TDC_Offsets/Deltat_raw/ histogram
- Run analysis script over output
- script for single run is macros/extract_ADC_Dt_Zcorr.C
- macros/monitor.py --adc4ns can be used to run over all runs
- Load constants to CCDB table /BCAL/ADC_timing_offsets using python macros/commit_CCDB.py -d output/ADCendDt/correction/ --adc
- Remove 32ns TDC hardware offset (pass 1)
- Set CCDB table /BCAL/TDC_offsets to 0
- Run reconstruction with BCAL_online plugin to produce the /bcal/bcal_Uhit_tdiff_raw_ave histogram (pass 1)
- Run analysis script over output
- script for single run is macros/extract_Uhit_tdiff.C
- macros/monitor.py can be used to run over all runs
- Load constants to CCDB table /BCAL/TDC_offsets using python macros/commit_CCDB.py -d output/tdiff/TDCcorrection/runs/ --tdc -v
- TDC timewalk correction (pass 2)
- Prerequisites:
- Remove 4ns ADC hardware offset
- Remove 32ns ADC hardware offset
- Run reconstruction with BCAL_TDC_Timing plugin
- Run analysis script over output
- script for single run is macros/fit_TDCtimewalk.C
- macros/monitor.py --timewalk can be used to run over all runs
- Load constants to CCDB
- Prerequisites:
- Position from end time-difference (pass 2)
- Prerequisites:
- Remove 4ns ADC hardware offset
- Run reconstruction with BCAL_TDC_Timing plugin
- Run analysis script over output
- script for single run is macros/
- ./macros/monitor.py --position can be used to run over all runs
- Load constants to CCDB
- Prerequisites:
- Calibrate the point time offset from tracking (pass 2)
- Prerequisites:
- Remove 4ns ADC hardware offset
- Run reconstruction with BCAL_TDC_Timing plugin
- Run analysis script over output
- Linear fit (needs ~1M events per run)
- script for single run is macros/fit_ZvsDeltaT_p1.C
- macros/monitor.py can be used to run over all runs
- Quadratic fit (needs 5 files per run)
- Linear fit (needs ~1M events per run)
- Load constants to CCDB
- Prerequisites:
- Attenuation length and gain ratio (pass 3)
- Prerequisites:
- position calibration (pass 2)
- Run reconstruction with BCAL_attenlength_gainratio plugin
- Run analysis script over output
- Load constants to CCDB
- Prerequisites: