CPP FCAL time/energy calibrations
From GlueXWiki
Revision as of 17:46, 23 August 2022 by Ijaegle (Talk | contribs) (→What is currently in the default variation)
Contents
List of changes
These lists are giving the run ranges where the FCAL hardware was not changed.
Monitoring results
What is currently in the default variation
The empty target periods used all the period 1 tables.
- period 0: 100408-100845
- period 1: 100961-101010
- period 2: 101011-101044
- period 4: 101076-101154
- period 8: 101255-101336
- period 11: 101439-101587
NB: the period is this section does not match the period in section "Period" but match the period in section ""
Periods
The periods in BOLD are calibrated i.e. have a pedestal and gain tables. Each period corresponds to constant FCAL and/or experimental conditions.
- period 1: 100408-100960
- period 2: 100961-101010
- period 3: 101011-101044
- period 4: 101045-101074 (empty target)
- period 5: 101076-101154 (some blocks set to 1 in block_quality)
- period 6: 101164-101166
- period 7: 101167-101254 (empty target)
- period 8: 101255-101336
- period 9: 101337-101392 (Hall B half-wave plate in)
- period 10: 101393-101402 (Hall B half-wave plate in & empty target)
- period 11: 101403-101438 (empty target)
- period 12: 101439-101529
- period 13: 101530-101535 (Hall B half-wave plate in)
- period 14: 101536-101587
- period 15: 101597-101609 (empty target)
Gain matching calibration plots
Checking the FCAL gains
Energy dependence correction monitoring plots
Timing calibration
- period 1: 100408-100960
- period 2: 100961-
Bad block map
This map is done for each run number by combining the info collected by analysing the LED and pi0 skims.