Difference between revisions of "Standard Beamline Quadrupole Specification"
From GlueXWiki
Line 1: | Line 1: | ||
− | Below is the spec for a standard JLAB QP magnet. At 19amps, it can just make the spec for the Hall D tagger. | + | Below is the spec for a standard JLAB QP magnet. At 19amps, it can just make the field spec for the Hall D tagger. |
<table> | <table> | ||
<tr bgcolor="#e0e0f0"><td>Bore</td><td align="right">3.81 cm</td><td>1.5 in</td></tr> | <tr bgcolor="#e0e0f0"><td>Bore</td><td align="right">3.81 cm</td><td>1.5 in</td></tr> | ||
Line 6: | Line 6: | ||
<tr bgcolor="#e0e0f0"><td> </td><td align="right">82 kG</td><td width="60%">at 19 A (depends on cable run)</td></tr> | <tr bgcolor="#e0e0f0"><td> </td><td align="right">82 kG</td><td width="60%">at 19 A (depends on cable run)</td></tr> | ||
</table> | </table> | ||
+ | |||
+ | Remaining questions are: | ||
+ | # How does cable run length control whether or not the quadrupole can reach 82 kG? Isn't that a power supply issue? | ||
+ | # What are the inner diameters of standard pipe sizes that fit through this bore? Can we find one that meets the 30±2 mm ID in the specification? |
Revision as of 12:32, 21 January 2008
Below is the spec for a standard JLAB QP magnet. At 19amps, it can just make the field spec for the Hall D tagger.
Bore | 3.81 cm | 1.5 in |
Length | 30.48 cm | |
Max B'l | 75 kG | at 18 A (design current) |
82 kG | at 19 A (depends on cable run) |
Remaining questions are:
- How does cable run length control whether or not the quadrupole can reach 82 kG? Isn't that a power supply issue?
- What are the inner diameters of standard pipe sizes that fit through this bore? Can we find one that meets the 30±2 mm ID in the specification?