Difference between revisions of "Private:UConn test setup"
From GlueXWiki
Line 55: | Line 55: | ||
* Connect keybord and monitor (if needed) to the Intel ROC. | * Connect keybord and monitor (if needed) to the Intel ROC. | ||
− | * Connect upper LAN connector to the Ethernet cable | + | * Connect ROC upper LAN connector to the Ethernet cable |
* Change ROC IP address (you will see the MAC address when you start booting the controller) | * Change ROC IP address (you will see the MAC address when you start booting the controller) | ||
* Login under '''halld''' | * Login under '''halld''' |
Revision as of 18:34, 21 September 2012
Boards in the crate
Board | Slot | Serial |
---|---|---|
CPU (halldtrg5) | 1 | |
TI (Old) | 2 | |
FADC250 | 5 | B21595_06R |
SDC | 9 | |
LE discriminator | 14 | C_15 |
F1TDC | 16 |
Front pannel connections
From | To |
---|---|
External trigger | TI input, IN1 |
L1 Accept ( 3rd from the bottom ) | SDC TRG |
L1 Accept ( 4 th from the bottom ) | F1TDC TRG |
TI Out0 | F1TDC SYNC |
Setting up the setup
- Connect keybord and monitor (if needed) to the Intel ROC.
- Connect ROC upper LAN connector to the Ethernet cable
- Change ROC IP address (you will see the MAC address when you start booting the controller)
- Login under halld