Difference between revisions of "GlueX Start Counter Meeting, May 3, 2012"
(notes as minutes) |
(→Minutes) |
||
Line 28: | Line 28: | ||
=Minutes= | =Minutes= | ||
− | + | Present: | |
− | + | * '''FIU''': Werner Boeglin, Puneet Khetarpal | |
+ | * '''JLab''': Mark Ito (chair), Elton Smith, Tim Whitlatch, Beni Zihlmann | ||
− | + | ==Prototype== | |
− | + | ||
− | + | The sample counter has still not come in from McNeal. It has been built and now is "in finishing." | |
+ | |||
+ | ==Read-Out== | ||
+ | |||
+ | Mark reported on his conversation with Fernando. Fernando has started thinking about the design of the SiPM board | ||
• 3 sectors ok | • 3 sectors ok | ||
• 3 bias voltages | • 3 bias voltages |
Revision as of 13:05, 3 May 2012
GlueX Start Counter Meeting
Thursday, May 3, 2012
10 am EDT
JLab: CEBAF Center, Room 326/327
Contents
Agenda
- Announcements
- Review minutes from previous meeting
- Prototype Report
- Readout Design
- Contract Status
- Simulation
Communication Information
Video Conferencing
- ESNet: 8542553
- EVO:
- Meeting URL: http://evo.caltech.edu/evoNext/koala.jnlp?meeting=eneueMvsv2aBaDInalIn
- Phone Bridge ID: 13 2615
Slides
Talks can be deposited in the directory /group/halld/www/halldweb1/html/talks/2012-2Q
on the JLab CUE. This directory is accessible from the web at https://halldweb1.jlab.org/talks/2012-2Q/ .
Minutes
Present:
- FIU: Werner Boeglin, Puneet Khetarpal
- JLab: Mark Ito (chair), Elton Smith, Tim Whitlatch, Beni Zihlmann
Prototype
The sample counter has still not come in from McNeal. It has been built and now is "in finishing."
Read-Out
Mark reported on his conversation with Fernando. Fernando has started thinking about the design of the SiPM board • 3 sectors ok • 3 bias voltages • outrigger board • thermister, not used ∘ elton and werner prefer it ∘ does set point temp need to be known in advance?
new geometry for stat counters ready • remove long light guides • puneet will do it • may have to add some material for sipm boards
LED system • usefull to vary intesnsity, check efficiency, if fsast, can look at timing resolution
Mechanical
• inner support to be machined out of one piece • no foam on the outside • light-tighting an issue