Revision as of 10:49, 10 January 2025

Connection

Meeting time and location:

• 9:30 am EST (JLab time) remote only
• Connection information

Agenda

Preparation of parts for ECAL -- Sasha

-New PCB and parts for the LMS light source arrived to the lab. The LMS board will be assembled and tested during next week.

-Consider to install two more temperature sensors (will try to fix the old ones first), a few sensors have been ordered

-Installation of the FCAL2 detector & integration to GlueX -- Sasha, All

• Implementing ECAL into the GlueX DAQ [1]

- Initial version of the VTP firmware ready. Started testing using a setup with one VTP during the holiday break (some progress has been made)

- VTPs installed on all ECAL VXS crates [2]

- Use new version of DAQ, VTP included as a DAQ component. Will be updated on the entire detector after the ECAL commissioning

• All HV distribution boards have been installed [3] [4] [5] [6] [7]

-Replace one HV module (problems with the interlock) [8]

• Update signal translation table [9]
• Update mapping of the ECAL high voltages and spare HV cables [10]
• Implement ECAL HV interlock based on the newly installed temperature sensors in the divider region
• Toook cosmic data with the entire detector powered [11][12]
• Temperature of the ECAL modules [13][14] [15][16]

Previous temperature scan in the ECAL divider region [17][18][19]/4321188[20]

• Safety documents and preparing for the run

Page for shift Takers

ECAL in the Experimental Safety Assessment Document (ESAD)

EPAS for Maintenance of the Hall D ECAL (Jlab-PTW-5236)

ECAL commissioning -- Sasha, All

Calibrations

• Gain calibration [21]
• Low-level timing
• Timing with respect to other detectors

Analysis/Simulation