Difference between revisions of "JEF meeting, January 10, 2025"
From GlueXWiki
(→Agenda) |
|||
| Line 24: | Line 24: | ||
* Update mapping of the ECAL high voltages and spare HV cables [https://logbooks.jlab.org/entry/4325047] | * Update mapping of the ECAL high voltages and spare HV cables [https://logbooks.jlab.org/entry/4325047] | ||
* Implement ECAL HV interlock based on the newly installed temperature sensors in the divider region | * Implement ECAL HV interlock based on the newly installed temperature sensors in the divider region | ||
| − | * Toook cosmic data with the | + | * Toook cosmic data with the entire detector powered [https://logbooks.jlab.org/entry/4324767] |
* Temperature of the ECAL modules | * Temperature of the ECAL modules | ||
:: Previous temperature scan in the ECAL divider region [https://logbooks.jlab.org/entry/4320981][https://logbooks.jlab.org/entry/4321406][https://logbooks.jlab.org/entry/4321241][https://logbooks.jlab.org/entr /4321188][https://logbooks.jlab.org/entry/4324242?destination=node/1397299] | :: Previous temperature scan in the ECAL divider region [https://logbooks.jlab.org/entry/4320981][https://logbooks.jlab.org/entry/4321406][https://logbooks.jlab.org/entry/4321241][https://logbooks.jlab.org/entr /4321188][https://logbooks.jlab.org/entry/4324242?destination=node/1397299] | ||
Revision as of 09:21, 10 January 2025
Connection
Meeting time and location:
- 9:30 am EST (JLab time) remote only
- Connection information
Agenda
Preparation of parts for ECAL -- Sasha
- -New PCB and parts for the LMS light source arrived to the lab. The LMS board will be assembled and tested during next week.
- -Consider to install two more temperature sensors (will try to fix the old ones first), a few sensors have been ordered
-Installation of the FCAL2 detector & integration to GlueX -- Sasha, All
- Implementing ECAL into the GlueX DAQ [1]
- - Initial version of the VTP firmware ready. Started testing using a setup with one VTP during the holiday break (some progress has been made)
- - VTPs installed on all ECAL VXS crates [2]
- - Use new version of DAQ, VTP included as a DAQ component. Will be updated on the entire detector after the ECAL commissioning
- ECAL HV interlock check [3]
- -Replace one HV module (problems with the interlock) [9]
- Update signal translation table [10]
- Update mapping of the ECAL high voltages and spare HV cables [11]
- Implement ECAL HV interlock based on the newly installed temperature sensors in the divider region
- Toook cosmic data with the entire detector powered [12]
- Temperature of the ECAL modules
- Safety documents and preparing for the run
- Page for shift Takers
- ECAL in the Experimental Safety Assessment Document (ESAD)
- EPAS for Maintenance of the Hall D ECAL (Jlab-PTW-5236)
ECAL commissioning -- Sasha, All
Calibrations
- Gain calibration
- Low-level timing
- Timing with respect to other detectors
Analysis/Simulation
