Difference between revisions of "Run Planning Meeting Notes, Jan 16-Jan 22, 2020"
From GlueXWiki
(→Friday, January 17 at 08:45) |
|||
(10 intermediate revisions by the same user not shown) | |||
Line 17: | Line 17: | ||
== Friday, January 17 at 08:45 == | == Friday, January 17 at 08:45 == | ||
# Last 24 hours | # Last 24 hours | ||
+ | #* High rate scan [https://logbooks.jlab.org/entry/3765099] | ||
+ | #* cDAQ | ||
+ | #* TOF thresholds | ||
# Issues | # Issues | ||
− | #* | + | #* Radiator scan results on Thursday [https://logbooks.jlab.org/entry/3764913 morning] and [https://logbooks.jlab.org/entry/3765010 noontime] |
# Tasks for today | # Tasks for today | ||
#* Production data taking | #* Production data taking | ||
#* RF recovery starting at 9 am | #* RF recovery starting at 9 am | ||
− | #* Accidental study (Richard), 1 pm. | + | #* Accidental study (Richard), 1 pm. 2100 nA beam, most HVs will be turned off, empty target. RadCon will monitor. [https://halldweb.jlab.org/wiki/index.php/Tagger_accidentals_rate_scan,_Fall_2019 Richard's proposal] |
#* Empty target run (2 hr) | #* Empty target run (2 hr) | ||
+ | #* 30 min runs at 250 and 350 nA? To check number of rho, omegas / trigger. All subsystems ready? | ||
# Plan for later | # Plan for later | ||
− | #* Happy three day weekend! 🙂 Production data | + | #* Happy three day weekend! 🙂 Production data. No studies or downtime planned until Tuesday. |
+ | #* Next meeting: Tuesday | ||
+ | |||
+ | == Tuesday, January 21 at 08:45 == | ||
+ | # Since Friday meeting | ||
+ | #* Accidental study: success up to 2100 nA! | ||
+ | #* Empty target run | ||
+ | #* Production data over weekend: increase to 250 nA | ||
+ | #* Upload of most recent f250 firmware to PS, TAGH, TAGM. Timing changed afterwards, monitoring plots affected, updated calibrations to test. PS rates also affected. | ||
+ | # Issues | ||
+ | #* Monday am: Hall D tagger went to restricted access? | ||
+ | #* Monday am: 5H00 [https://cebaf.jlab.org/dtm/all-events?incidentId=7638&qualified= vacuum fault] | ||
+ | #* Monday pm: [https://cebaf.jlab.org/dtm/all-events?incidentId=7641&qualified= solenoid dump]. Scott brought back to OK state, cause unclear. | ||
+ | # Tasks for today | ||
+ | #* Hall open until 1 pm. | ||
+ | #** Controlled access: solenoid investigations, FCAL base replacements, DIRC experts. Any others? | ||
+ | # Plan for later | ||
+ | #* Production, when we can! | ||
+ | |||
+ | == Friday, January 17 at 08:45 == | ||
+ | # Last 24 hours | ||
+ | #* Work in hall | ||
+ | #* Accelerator work, no good beam... | ||
+ | # Issues | ||
+ | # Tasks for today | ||
+ | #* Verify TAGH, TAGM, PS, ST after firmware upgrades | ||
+ | #* Production data taking | ||
+ | # Plan for later | ||
+ | #* More production |
Latest revision as of 09:41, 22 January 2020
Contents
Thursday, January 16 at 08:45
- Last 24 hours
- Trippy beam yesterday and overnight. Issues in two cryomodules.
- Some production data was collected.
- L1 triggers studies have been postponed to today.
- Issues
- Major bleed through, presumably from Hall A 1-pass beam 3764868
- Tasks for today
- After spin dance (11 am -3 pm in accelerator plan): L1 triggers studies (Sasha, Beni, Justin)
- Followed by cDAQ test (Sergey)
- Production data otherwise
- Plan for later
- Tagger accidental study (Richard). Tomorrow early a.m.? Will contact RadCon for final ok. Richard's proposal
- Empty target run (target will already be emptied for accidental study).
- Discussion of 24 GeV physics came up, physics ideas are welcome.
Friday, January 17 at 08:45
- Last 24 hours
- High rate scan [1]
- cDAQ
- TOF thresholds
- Issues
- Tasks for today
- Production data taking
- RF recovery starting at 9 am
- Accidental study (Richard), 1 pm. 2100 nA beam, most HVs will be turned off, empty target. RadCon will monitor. Richard's proposal
- Empty target run (2 hr)
- 30 min runs at 250 and 350 nA? To check number of rho, omegas / trigger. All subsystems ready?
- Plan for later
- Happy three day weekend! 🙂 Production data. No studies or downtime planned until Tuesday.
- Next meeting: Tuesday
Tuesday, January 21 at 08:45
- Since Friday meeting
- Accidental study: success up to 2100 nA!
- Empty target run
- Production data over weekend: increase to 250 nA
- Upload of most recent f250 firmware to PS, TAGH, TAGM. Timing changed afterwards, monitoring plots affected, updated calibrations to test. PS rates also affected.
- Issues
- Monday am: Hall D tagger went to restricted access?
- Monday am: 5H00 vacuum fault
- Monday pm: solenoid dump. Scott brought back to OK state, cause unclear.
- Tasks for today
- Hall open until 1 pm.
- Controlled access: solenoid investigations, FCAL base replacements, DIRC experts. Any others?
- Hall open until 1 pm.
- Plan for later
- Production, when we can!
Friday, January 17 at 08:45
- Last 24 hours
- Work in hall
- Accelerator work, no good beam...
- Issues
- Tasks for today
- Verify TAGH, TAGM, PS, ST after firmware upgrades
- Production data taking
- Plan for later
- More production