Difference between revisions of "Microscope Prototype Beam Test"
From GlueXWiki
Senderovich (Talk | contribs) (→Counter positioning) |
Senderovich (Talk | contribs) (→Counter positioning) |
||
Line 24: | Line 24: | ||
** Coordinates: | ** Coordinates: | ||
** Position instructions: | ** Position instructions: | ||
− | *** x-axis: the line marked on the sides of the foil window indicates the 0±2mm position of the scintillating fibers. | + | *** x-axis: the line marked on the sides of the foil window indicates the 0±2mm position of the scintillating fibers. (±8mm motion is possible) |
** Discriminator selection/positioning instructions: | ** Discriminator selection/positioning instructions: | ||
Revision as of 12:24, 14 October 2010
The purpose of this note is to gather all the information pertinent to the beam test of the tagger microscope prototype in Hall B planned for the fall of 2010.
Contents
Introduction
- Proposal: [link TBA]
Schedule
- JLab visit dates by UConn group:
- Oct 8-15, 2010 (personnel: Richard J., Igor S.) Goals:
- instrumentation staging - testing of DAQ with microscope out of the Hall (on the bench)
- Oct 8-15, 2010 (personnel: Richard J., Igor S.) Goals:
Setup
Counter positioning
- Hall B Tagger Montecarlo
- Source [link TBA]
- Results [TBA]
- Selected position: [info TBA]
- Coordinates:
- Position instructions:
- x-axis: the line marked on the sides of the foil window indicates the 0±2mm position of the scintillating fibers. (±8mm motion is possible)
- Discriminator selection/positioning instructions:
DAQ setup
Configuration
Connection/Operation instructions
- interface?
- remote connection?