|
|
(38 intermediate revisions by 4 users not shown) |
Line 1: |
Line 1: |
− | * '''Telephone meeting April 3, 2007''' [''Elke's notes'']
| + | |
− | {| align="right" width="95%"
| + | |
− | |
| + | |
− | Sergey will be at Jefferson lab 30.04-07 - 01.05.07, we will have a meeting on April 30th with Franz coming to JLAB and Richard and ? joining by video. Sergey will provide electronic versions of the drawing before this meeting to allow all people enough time to look to them and make remarks.
| + | |
− | |-
| + | |
− | |
| + | |
− | In general the drawing follow the design from Jim Kellie and G. Yang. Special care should be taken to avoid stress on the vacuum chamber and o-rings. Franz will provide a list of hot topics on the design discussed in the past. Richard will provide Sergey where to find all the relevant information on
| + | |
− | the wiki. We will have a tagger-email list, which will have the list of people above pre-registered please tell your students or postdocs or .. to register so all the information is archived and all people are always informed.
| + | |
− | |}
| + | |
− | * '''Discussion and questions regarding the Serpukov tagger design drawings'''
| + | |
− | ''Franz Klein'': The design effort should address the following areas of concern.
| + | |
− | *# Field and trajectory changes due to small misalignment of the magnets: this was answered in detail by Yang's simulation.
| + | |
− | *# Stress on vacuum chamber with 2 big magnets attached (relative motion of energized magnets and evacuated chamber).
| + | |
− | *# Sealing the large vacuum chamber at the contact with the magnets: large o-rings.
| + | |