Difference between revisions of "Solenoid Coil Test in Test Lab"

Revision as of 14:00, 18 June 2009

Notes and to-do lists for the solenoid coil tests this summer and fall.

Test Area

• Notes:
  • Area in the test lab is 20'6" x 25'9", currently filled with coils and coil parts.
  • May be able to get space in adjacent area (QWeak construction and SRF cavity storage areas).
  • May need extra space for large power supply (6' x 5') and to avoid placing controls racks in large B field.
  • Must maintain clear areas around racks and power supply, and cannot block pedestrian walkways.
  • Platform is 172" x 160", cryo can will sit on top.
  • Area has two cranes, but need both (and spreader bar) to lift heaviest yoke (45 tons).
  • Need come-alongs and anchors to move yokes and coils along rails.

• To Do:
  • Look into getting space in adjacent areas - George
  • Look into possibility of locating computer in control room - Elliott
  • Distribute Floyd's B field map for single coil, no cladding - George
  • Determine location of all components - Wayne
  • Arrange for piping designer - George
    • Design piping to vent N2.
    • Design warm and cold He supply/return systems, LN2 supply system.
  • Investigate sensitivity of electronic equipment to B fields - Elliott

• • Verify we have all cryo transfer lines and U-tubes - Mark S
  • Verify we can borrow heat exchanger from Hall A - George
  • Order warm He and N2 piping - ?
  • Retrieve rails from IU - ?

Infrastructure

• Notes:

• To Do:

Components

• Notes:

• To Do:

Staging

• Notes:
  • Will instrument controls racks in F117, then move to Test Lab.
  • Will instrument for final 4-coil system.

• To Do:
  • Rearrange F117 - Mark S and Beni
  • Get and move 3 racks into F117 - Mark S

Reviews

• Notes:
  • Micro-review of PLC vendor choice completed, waiting for report.

• To Do:
  • Write thank-you letter to Jonathan Creel and Omar Garza for participating in PLC vendor review.