TODO reprocessing 2017-01 data

From GlueXWiki
Revision as of 09:21, 25 April 2022 by Sdobbs (Talk | contribs) (FCAL plots)

Jump to: navigation, search

Things to do before reprocessing the 2017 data with the latest software

Need to do

  • Recalibrate inner FCAL blocks
    • Decide if we should use the Primex calibration procedure
  • Check tagger calibrations
  • Benchmark reconstruction software against 2019-11 software version

Would like to do

  • Figure out drift chamber alignment
  • study matching to single FCAL blocks
  • detailed tagger energy calibration
  • better calibration of high energy FCAL showers

FCAL plots

pi0 mass for inner blocks in run period 2017-01 (run 30730) - 25 April 2022 (pdf)

InnerBlocks 30730-20220425.png

pi0 mass for inner blocks in run period 2018-08 (run 51227) - 25 April 2022 (pdf)

InnerBlocks 51227-20220425.png

pi0 mass for inner blocks In run period 2017-01 (note that these plots were made using the pi0 skims, whereas the above plots were made with the full raw data, so ignore this plot!! the pi0 skims explicitly rejected in the inner FCAL layers)- 20 April 2022

InnerBlocks-2017-01 20220420.png