PrimEx-eta phase1 FCAL energy calibration
From GlueXWiki
Revision as of 16:53, 8 February 2022 by Ijaegle (Talk | contribs) (Created page with "== List of changes == These lists are giving the run ranges where the FCAL hardware was not changed. == Monitoring results == The monitoring results can be found here: [htt...")
Contents
List of changes
These lists are giving the run ranges where the FCAL hardware was not changed.
Monitoring results
The monitoring results can be found here: [1]
Periods
All periods listed here are calibrated on the default variation
Gains matching calibration monitoring plots
Checking the FCAL gains
Energy dependence correction monitoring plots
Timing calibration
Bad block map
This map is done for each run number by combining the info collected by analysing the LED and pi0 skims.