Difference between revisions of "GlueX TOF Meeting, March 15, 2012"
From GlueXWiki
(Created page with "Thursday, March 15, 2012<br> 10:00 am EST<br> JLab: ARC, Room 428<br> =Agenda= # Announcements # Minutes from the last meeting # Me...") |
(notes as minutes) |
||
| Line 30: | Line 30: | ||
=Minutes= | =Minutes= | ||
| + | still working on light guides | ||
| + | |||
| + | from discussions last week, good recommendations | ||
| + | from bent 1/2 inch plate to machine a channel | ||
| + | simplifies | ||
| + | grab by the light guide only | ||
| + | what about pressure from the whole assembly | ||
| + | flat section .4", 1 cm | ||
| + | full scale model to see if support | ||
| + | 1/4 scale full frame | ||
| + | aim for tuesday, for next design meeting | ||
| + | 4 pm mon send out draft drawings | ||
Revision as of 16:43, 18 March 2012
Thursday, March 15, 2012
10:00 am EST
JLab: ARC, Room 428
Contents
Agenda
- Announcements
- Minutes from the last meeting
- Mechanical design: Tim, Chuck
- Prototype status: Paul, Sasha
- TDC choice: all
- Contract Status: Mark, Paul
- Calibration and Alignment discussion.
Communication
Videoconference
- ESNet: 8542553
- EVO: EVO site
Slides
Talks can be deposited in the directory /group/halld/www/halldweb1/html/talks/2012-1Q on the JLab CUE. This directory is accessible from the web at https://halldweb1.jlab.org/talks/2012-1Q/ .
Chairman's Cell Phone
(757)504-0664.
Minutes
still working on light guides
from discussions last week, good recommendations from bent 1/2 inch plate to machine a channel simplifies grab by the light guide only
what about pressure from the whole assembly
flat section .4", 1 cm full scale model to see if support 1/4 scale full frame aim for tuesday, for next design meeting 4 pm mon send out draft drawings
